June 2022
Installation, Operation and Maintenance Manual
VCIOM-01494-EN Rev. 0
8
Installation
Section 2: Installation
Figure 12
• Place the OM1 card onto the heatsink spacers and tighten the 4 screws; assemble
local mechanical indicator shown in Figure 13.
• Connect the following connector as shown in Figure 14:
— the 8-pin connector to connector J3 on OM1
— the 4-pin connector to connector J2 on OM1
— the 3-pin connector to connector J6 on OM1
— the 2-pin connector to connector J7 on OM1
Figure 13
Figure 14
screw
To Next Page
Loading...
