Installation, Operation and Maintenance Manual
VCIOM-01494-EN Rev. 0
June 2022
7
Installation
Section 2: Installation
2.2 Assembling Procedure for Models
250-500-1000-2000 Nm Old Version
(US or Non-US Market)
• Detect the 4 black cables required for the OM1 which are already included in the
basic actuator; disassemble local mechanical indicator as shown in Figure 10.
Figure 10
• In Figure 11, connect the at cable furnished into the kit to connector J9 on OM1.
• In Figure 12, connect the OM1 at cable to the connector on the logic board.
Figure 11
To Next Page
Loading...
