Emerson Liebert GXT MT+LB 10KL - Page 18

17
3-6-2. LCD Setting
At the main interface; press and hold the “up” and “down” buttons simultaneous for more than 1 second to enter
or escape from setting menu.
There are two parameters to set up the UPS. Refer to following diagram.
Parameter 1: It’s for program alternatives.
Refer to below table for the details.
Parameter 2: Setting options or values for each
program.
11 programs available list for parameter 1:
Code
Description Bypass AC CVCF
Battery
Battery
Test
01 Output voltage Y
02 CVCF mode enable/disable Y
03 Output frequency Y
04 Bypass mode open/forbidden Y Y
05 Bypass mode enable/disable Y Y
06 Battery backup time setting Y Y Y Y Y
07 Hot standby function enable/disable Y Y Y Y Y
08 Voltage range for bypass –low loss Y
09 Voltage range for bypass –high loss Y
10 Frequency range for bypass –low loss Y
11 Frequency range for bypass –high loss Y
12 Battery voltage Calibration Y Y Y Y Y
13
Charger voltage adjustment
Y Y Y Y Y
14
Inverter voltage Calibration
Y Y Y
15 Charger maximum current setting Y Y Y Y Y
16 Battery capacity setting Y Y Y Y Y
17 Battery groups setting Y Y Y Y Y
18 Backup time calibration Y Y Y Y Y
*Y means that this program can be set in this mode.