Emerson Liebert GXT4-700RT230 - Default Screen; Main Menu Screen

16 Chapter 3 Operation And Display Panel
Liebert GXT4 UPS 700VA ~ 3000VA (230V) User Manual
3.3.3 Default Screen
Press any button in the ‘STATTUP SUCCESSFULLY’ screen to enter the default interface, as shown in Figure 3-5.
Figure 3-5 Default screen
In the default screen, the LCD display panel will display the UPS model, operation mode (ONLINE, GREEN, GREEN
AUTO, and BYPASS), output parameters, input parameters, battery capacity and load percentage.
If no control button is pressed within two minutes, the LCD display panel will enter a screen-protection state (the back
lighting is off) until any control button is pressed.
3.3.4 Main Menu Screen
Press any button in the default screen to enter the Main Menu screen, as shown in Figure 3-6.
1 STATUS
2 CONFIGURATION
3 CONTROL
4 LOG
5 ABOUT
Figure 3-6 Main Menu screen
To select a submenu, press the UP or DOWN button to move the cursor to the required item, and press the ENTER
button to enter its submenu or set its parameter.
STATUS screen
Select Main Menu -> 1 STATUS to enter the STATUS screen, displaying OUTPUT, LOAD, INPUT, BATTERY and
TIME SINCE STARTUP, as shown in Figure 3-7.
VOLTAGE : 120V
FREQUENCY : 60HZ
CURRENT : 17.6A
POWER : 2112KWH
OUTPUT
CAPACITY : 90%
RUNTIME : 100MINS
VOLTAGE : 80V
BATTERY
TIME SINCE STARTUP
05D 15H 30M
Figure 3-7 STATUS screen
CONFIGURATION screen
Select Main Menu -> 2 CONFIGURATION to enter the CONFIGURATION screen. This menu has eight submenus, as
shown in Figure 3-8.