23
NOTE: After you press MEMORY/CLOCK ADJ. button the first time, you must
press PRESET or , and MEMORY/CLOCK ADJ. buttons within 10 seconds,
while the MEMORY indicator is flashing on the display, or your station will not
be memorized.
If the MEMORY indicator stops flashing press the MEMORY/CLOCK ADJ.
button once to start the indicator flashing again, then press PRESET or ,
and MEMORY/CLOCK ADJ. buttons again to memorize your station.
Recalling Preset Stations
1.) Turn the system ‘On’, press the STOP/BAND button to select the Tuner
function and the desired band.
2.) Press the PRESET or button repeatedly until the desired preset number
and frequency appears on the display.
• You may also use the number buttons on the remote control to directly select
the desired preset memory number.
• Simply press the corresponding number key on the remote handset to select
preset memory numbers 1 through 9.
• To select preset memory number 10, press the “+10” button and then the “0”
button.
Changing Preset Stations
1.) Tune to the new station you want to memorize and press the MEMORY/CLOCK
ADJ. button to start the MEMORY indicator flashing.
2.) Repeatedly press the PRESET or button until the display shows the
number of the preset memory you wish to change.
3.) Press the MEMORY/CLOCK ADJ. button again. The new station is entered in
the memory and the previous station is deleted.
MS3108_062806.p65 28/6/2006, 16:5423
To Next Page
Loading...
Need help?
General
