18
Setting The Clock
When the system is connected to an AC outlet the STANDBY button light comes
‘On’.
The time display will show a flashing
“AM 12:00”.
This is your indication that the time is incorrect and needs to be set.
NOTE: Although it is not necessary to set the clock in order to listen to the
radio or CD player, the clock must be set correctly if you intend to use the
timer to turn the system ‘On’ and ‘Off’ automatically.
Do not press the STANDBY (POWER) button. The system must be in the Standby
mode to set the clock.
You have the option of displaying the time in 12-Hour or 24-Hour modes.
12-Hour Mode - The time is displayed in 12-hour cycles with AM / PM indicators.
This is the factory default setting.
24-Hour Mode - The time is displayed in 24-hour cycles with no AM / PM indicators.
This is sometimes referred to as “Military Time”.
For example, “PM 6:00” would be displayed as “18:00”.
1.) Depress the MEMORY/CLOCK ADJ. button, “12Hr” flashes in the display.
Then press either the or buttons to alternatively to switch between
the 12-hour and 24-hour display modes.
MS3108_062806.p65 28/6/2006, 16:5418
To Next Page
Loading...
