7
Installing The Remote Control Batteries
The remote control requires two “AAA” batteries, not included. We recommend
that you use a well known brand of alkaline batteries for longest life and best
performance.
Open the remote control battery compartment by sliding the battery compartment
cover in the direction of the ‘arrow’.
Install two “AAA” batteries in the compartment according to the polarity markings
inside the compartment as shown in the illustration. If the batteries are installed
incorrectly the remote control will not work. After installing the batteries replace the
battery compartment cover.
NOTE: When the operation of the remote control becomes intermittent or stops
working completely replace the batteries as soon as possible. Never leave
weak or exhausted batteries in the remote for an extended period of time.
They may eventually leak and cause permanent damage to the remote control.
Battery Precautions
• Replacement of batteries must be done by an adult.
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium)
batteries.
• The supply terminals are not to be short-circuited.
• Non-rechargeable batteries are not to be recharged.
• Exhausted batteries are to be removed.
• Only batteries of the equivalent type are to be used.
• Batteries are to be inserted with the correct polarity.
• Dispose of batteries properly. Do not dispose of batteries in fire. The batteries
may explode or leak.
MS3108_062806.p65 28/6/2006, 16:547
To Next Page
Loading...
Need help?
General
