This needs to be repeated for both straps. This is done by
using the torque wrench and 8 mm socket.
NPS > 2 to NPS 12 5 N-m
NPS 12 to NPS 48 15 N-m
Note
When torquing the worm drives, ensure that the band which
has the two worm drive band mounted remains opposite to
the device. Refer to Figure 3-5. Once the straps have been
torqued, cut any excess strapping using the tinsnips.
Figure 3-5: Ideal location of the worm drive band
Quick Start Guide May2024
22 Emerson.com/Rosemount
To Next Page
Loading...
