Page: 11
DIN Rail Mounting
1� Tilt and place the unit onto the DIN rail�
2� Push the unit downward until it stops�
3� Push at the lower front edge to lock� Ensure that
the retainer has locked�
Figure 6: Mounting the UPS DIN Rail
Removing the Unit from the DIN Rail
Push the button and swing the bottom out and up�
Figure 7: Removing the UPS
WARNING
Risk of electric shock, disconnect AC main power source before wiring. Battery Circuit is not
isolated from ac input, hazardous voltage may exist between battery terminals and ground - Test
before touching.
Ensure proper grounding.
INSTALLATION NOTICE
Before applying AC power, check impedance between the output neutral terminal on UPS and
ground with a multimeter (load connection made, UPS in off state).
The meter must read high impedance (>100 KOhms).
To Next Page
Loading...
