Emerson SolaHD SDU AC B Series - 6.0 Operating Instructions; Turning On the UPS; Turning Off the UPS; Alarm Management

Page: 13
6.0 Operating Instructions
TURNING ON THE UPS
Initial Power On
The UPS is shipped with PowerLock enabled� PowerLock is a feature designed to prevent accidental turn on
oftheUPSwhenintransit.ToturnoffPowerLockandgettheunitreadyforrstuse,Followthestepsbelow
(note: turn the UPS off and press the power button for 11-12 seconds until audible alarm sounds to enable
PowerLock feature if needed)�
1� Connect the UPS input to AC (120 or 230 Vac depending on model) with no load connected
2� Press the power ON/OFF button until audible alarm sounds (typically between 3 to 4 seconds) to disable
the power lock feature, Unit is now ON and power lock feature is OFF(unit does a self check and then Green
LED will illuminate and remains lit)
3� Turn the UPS unit OFF by pressing the ON/OFF button again until audible alarm silences and then release
the button
4� Leave the unit connected to AC for 4 hours min (8 hours recommended) to re-charge the battery (UPS will
charge weather output is ON or OFF)
5� Unit is ready for use�
•Press the POWER ON/OFF/TEST button for more than 2 seconds and the LEDs will turn ON�
NOTE: If utility power is not present, the UPS will be in back-up mode� The load will be powered from the
internal batteries until the discharge point is reached�
NOTE: The factory ships unit with Power Lock Feature enabled� This is to avoid accidental startup of the UPS
during shipping via the push button�
•To DISABLE – end user needs to apply desired AC input on the UPS Input AC connector then press the
On/OFF Power button for >10secs and release to turn on the unit�
•To ENABLE - apply AC input then press the On/OFF Power button for >10secs and release�
TURNING OFF THE UPS
•Hold the POWER ON/OFF/TEST button until the alarm is silenced�
ALARM
•Factory default setting is alarm enabled�
•To enable/disable Alarm:
•When the UPS is in back-up mode, press the POWER ON/OFF/TEST button for at least 1 second to silence
the alarm (this function is disabled when the UPS status is either LOW BATTERY or OVERLOAD MODE)� To
re-enable the alarm, press the POWER ON/OFF/TEST button for at least 1 second� Additionally, you can
enable/disable the alarm via UPSwatch Software�
SELF TEST
•ThisUPShasaself-diagnosticfeaturethatveriesboththeoperationoftheUPSandthecondition
of the battery�