4 – 6
Section 4 • Operation
VSS/VSR/VSM/VSH/VSSH Compressor • Installation, Operation and Service Manual • Emerson • 35391S
5. On the main screen, press “Menu” then press the
“Slide Calibration” button to enter the slide calibra-
tion screen, see Figure 4-4.
6. If the compressor unit is starting for the rst time
or a new actuator was installed, connect connec-
tors of power cable and position transmitter cable
to new actuator.
Figure 4-4. Menu Screen and Slide Calibration Button (Vission 20/20)
To Next Page
Loading...
