How to Move a Parameter From Pr1 to Pr2 Level and Vice Versa Fast Access Menu • 23
13 Fast Access Menu
The Fast Access menu contains the list of probes and values that are automatically emptied by the board such
as the superheat and percentage of valve opening. The values: nP or noP stands for probe not present or value
not emptied, and Err means the value is out of range, or the probe is damaged, not connected or configured
incorrectly.
ENTERING THE FAST
ACCESS MENU
Press and release the up arrow key. The duration of
the menu in case of inactivity is about 3 minutes.
Depending on the configuration of the board, the
values display.
To select an entry, press the
or
, then press to
view the value or to move to the
next value.
HM Acces
s to clock menu or reset the RTC alarm
An Va
lue of analog output
SH Value of superheat. nA= not Available
oPP Percentage of valve opening
dP1 (Pb1) Value read by
probe 1
dP2 (Pb2) Value read by
probe 2
dP3 (Pb3) Value read by
probe 3
dp4 (Pb4) Value read by
probe 4
dP5 (Pb5) Temperature read by probe 5 or value obtained from pressure
transducer
dP6 (Pb6) V
alue read by
probe 6
dPP Pressure value read by (Pb5) transducer
rPP V
irtual pressure probe, only on slave
L°t Minimum room temperature
H°t Maximum room temperature
dPr Virtual probe for room temperature regulation [rPA and
rPb]
dPd Virtual probe
for defrost management [dPA and dPb]
dPF Virtual probe for fan management [FPA and FPb]
rSE
Real thermoregulation setpoint: the value includes the sum of SET,
HES an
d/or the dynamic setpoint if the functions are
EXIT
Press together or wait the time out for 60 seconds.
Table 13-1 - Fast Access Menu
To Next Page
Loading...
