Page 108
DISASSEMBLY/DISPOSAL
For disassembly of the differential temperature
controller smart Sol, reverse assembly procedure:
- Disconnect the power supply.
- Open the terminal cover.
- Disconnect all cables.
- Release the wall screw fastening.
- Remove the controller from its mounting location.
Important!
The person who or the institute which is responsible for disposal of
the device must not discard the controller with the residual waste, but
must ensure correct recycling in accordance with the local provisions!
In case of doubt, ask the local disposal company or the
authorized dealer from which you have purchased the device.
Danger!
Mortal danger due to electrocution!
Before opening the terminal cover,
disconnect all poles of the power supply reliably!
Danger!
Mortal danger due to electrocution!
When removing the controller, secure all stripped
cable ends so that they cannot be touched by persons!
Remove cables completely on denite removal.
To Next Page
Loading...
