Page 14
WALL-MOUNTING
1 Fasten the top securing bolt so
that a space of 2 to 3 mm is
created between the wall and
the screw head.
2 Move the device so that the
upper fastening port is located
above the screw head ...
3 ... and push it downwards.
4 Fasten the lower securing bolt.
If necessary, use dowel
pins for wall-mounting!
Important!
The device corresponds to protection type IP 20 - make sure the
appropriate prerequisites exist on the envisaged place of installation.
Do not use the housing base as drill template.
A device with damaged housing must not be operated!
To Next Page
Loading...
