HYDROMASSAGE JETS
LARGE HYDROMASSAGE Jets - This jet provides a unique, pulsating
massage. The water flow is adjustable in that it can be turned from low
to high (by rotating the jet faceplate ¼ turn).
MIDSIZE DIRECTIONAL JET - These jets allow you to redirect the
jet stream by changing the position of the nozzle. The water flow is
adjustable in that it can be turned from low to high (by rotating the jet
faceplate ¼ turn).
MIDSIZE ROTATIONAL JET - These jets provide a rotating massage
pattern. The water flow is adjustable in that it can be turned from low to
high (by rotating the jet faceplate ¼ turn).
Mini JET - These jets deliver a direct, more focused massage. The
water flow is adjustable in that it can be turned from low to high (by
rotating the jet faceplate ¼ turn).
WATERFALL VALVE
(E500 & E700)
Your fitness system is equipped with a waterfall feature.
It is activated by turning on the hydromassage jets
(either low or high speed). The flow is regulated by
turning the waterfall valve on the inside wall of the
fitness system.
AIR CONTROLS
Your fitness system is equipped with two air valves. The
air valves will add or remove air to the hydromassage jet
system. Rotate valve to see which hydromassage jets are
affected.
SWIM MACHINE-HYDRAULIC
SWIM MACHINE OPERATION - Two teal remote controls have been
provided with your system and have
been packaged in the owner's packet
inside the equipment compartment.
The swim machine is turned on
through the use of the remote control,
which also adjusts the speed of the current
faster or slower. When changing speed,
you must press and hold the buttons on the
remote, then wait a few seconds for the current
to adjust. Upon initial start-up you will find that the unit has been set to
its lowest speed; which is a barely perceptible current. You will need
to press and HOLD the FASTER button to increase the speed. The
standard top speed is roughly equivalent to a 1:14 / 100 meters
(1:08 / 100 yard) pace a speed for expert
swimmers only. Set the water
speed at a comfortable level for your needs. Remotes are water resistant
but can not be submerged.
To stop swimming, simply press the on/off button on the remote. If left
running, the power unit will turn off automatically after thirty minutes
and can be restarted by pressing the on / off button again. Once you
have found an optimal speed for yourself, you may leave the system
at that setting. The controller for the swim machine is designed with a
“ramp-up” feature which forces the swim machine to start slowly, but will
increase to the last setting at which someone swam.
When you are first learning to swim in the swim current, it is often
useful to allow yourself to drift back to the rear of the fitness system. Let
your feet rest on the rear seat and then swim forward into position. By
starting from the back, you can get a feel for just how much room you
have. When
swimming, center your outstretched arm about 30 cm from
the front grill
.
TREADMILL-HYDRAULIC (OPTIONAL)
TREADMILL OPERATION - Two grey remote controls have
been provided with your system and have been packaged in the
owner's packet inside the equipment
compartment. These remotes are identical
to the swim machine remotes but a
different color.
Upon initial start-up you will find that unit
has been set to its lowest speed. You will
need to press and HOLD the FASTER
button to increase the speed.
The treadmill is turned on through the use of a remote control, which
also adjusts the speed of the treadmill faster or slower. When changing
speed, you must press and hold the buttons on the remote, then wait a
few seconds for the treadmill to adjust. Set the speed at a comfortable
level for your needs.
Remotes are water resistant but can not be
submerged.
NOTE: Depending on duration, temperature, and speed, users may
experience slight pulsing when the treadmill is operated on the slowest
speed settings. This action is caused by the natural rotation of the
hydraulic motor and will lessen as the treadmill speed is increased.
To turn off the treadmill, simply press the on/off button on the remote. If
left running, the power unit will turn off automatically after
thirty minutes and can be restarted by pressing the on / off button
again. The treadmill will always default to the slowest speed when turned
on.
Page 14
Getting Started
To Next Page
Loading...
Need help?
General
