FIRMWARE UPDATE
Firmware updates bring new features or bug fixes. Feel free to write any bugs, ideas
or improvements to beta@endorphin.es
Update procedure video: https://youtu.be/J89PHM04ZJk
To update the firmware on your module, first download the latest firmware file once
available from ENDORPHIN.ES website: GHOST — ENDORPHIN.ES
The update procedure is done via audio: either computer or phone will work, we
advise you to disable all notifications (flight mode) so that the update is not
interrupted.
1. Power OFF your modular system
2. Unplug all the cables from GHOST except a simple mono or stereo cable
connecting the audio output from your computer headphones output to the
AUDIO IN 1 input of the module
3. Set the output volume of your computer to 100% or slightly lower
4. Hold ROUTING while powering your system ON - you will see both CLIP and
/ ENV DEPTH* LEDs on
5. Open the GHOST_UPDATE_XXX.WAV file with any audio player. Press play
and wait 1.5+ minutes while the firmware is updating. Both CLIP and / ENV
DEPTH* LEDs will slowly blink during that procedure and a row of 4 buttons
will show the approximate signal level as imaginary VU meter. Try to adjust
the volume of the update so it will not clip but also will be enough level to
blink the VU meter
6. If all 4 buttons LEDs blink fast during update or both CLIP and /ENV
DEPTH* LEDs stop blinking, that means an error occurred in the update and
you have to stop the audio file playback, reset the firmware listening input
(single ROUTING button press), adjust the audio file playback volume and
then start it again
7. The module will reboot automatically after new firmware installed and will act
normally with TAP button blinking. That’s a good sign that update was
successful
8. To ensure the hidden parameters are all properly set after the update, it is
also recommended to make a module’s reset by simultaneously pressing and
holding all its 4 buttons for 3 seconds (see page 15)
9. Enjoy the new features.
🠚 IMPORTANT: to prevent the errors during the audio playback of the
firmware, please use any audio editor without any effects applied (EQ, room
correction etc.)
To Next Page
Loading...