CONNECTING THE POWER
Before installing a new module in your case, ensure your power supply has a free
power header and sufficient available capacity to power the module.
Connect the module directly to the power bus-board with supplied 10-16 ribbon
cable like any other eurorack module. Pair of RED / BROWN pins on the multicolor
ribbon cable corresponds to negative -12V .
Make sure to align the power cable with the ‘RED/BROWN STRIPE ’ label on the
module that corresponds to -12V, to the 10-pin connector and with typically a white
line for the 16-pin connector on the bus board.
TECHNICAL SPECIFICATIONS
🠚 Width: 16 HP/TE, depth: 25 cm or 1 ″ with inserted ribbon cable
🠚 Current draw: +12V: 130 mA, -12V: 35 mA
🠚 Audio I/O: 24 bit 96 kHz with 32 bit floating point internal processing
🠚 CV capture: 16 bit, 2 kHz
🠚 CV range: 0…+5V typically with up to 0…+10V. -5…+5V for 1v/oct and vcf cv .
🠚 Audio input range: typical eurorack standard +/-5V (10Vpp) with up to 18Vpp
when saturation starts (at around +21 dBu)
🠚 Audio output: typical +/-5V eurorack standard
FEATURED OVERVIEW / DEMO VIDEO
🠚 https://youtu.be/YGxffD8169g
🠚 https://youtu.be/dMv1zkeLZho
🠚 https://youtu.be/_OWo_KKaxp0
🠚 https://youtu.be/xTAsE5YUysQ
🠚 https://youtu.be/57UaTmpjyPQ
To Next Page
Loading...