Cerabar S FOUNDATION Fieldbus Commissioning
Endress+Hauser 25
5.4 Pressure measurement
5.4.1 Information on pressure measurement
!
Note!
• A Quick Setup menu is available for each of the measuring modes Pressure and Level which
guides you through the most important basic functions. With the setting in the MEASURING
MODE parameter, you specify which Quick Setup menu should be displayed. See also
Section 5.2 "Selecting the language and measuring mode".
• For a detailed description of the parameters, see Operating Instructions BA303P "Cerabar
S/Deltabar S/Deltapilot S, Description of Device Functions"
– FF: Table, Pressure Transducer Block
– FieldCare: Table, POSITION ADJUSTMENT
– FieldCare: Table, BASIC SETUP
– FieldCare: Table, EXTENDED SETUP
5.4.2 Quick Setup menu for the Pressure measuring mode
P01-PMx7xxxx-19-xx-xx-en-078
Fig. 8: Quick Setup menu for the "Pressure" measuring mode
1) 1)1)
1)
2)
POS. ZERO ADJUST
Gauge pressure
sensors
Absolut pressure sensors
POS. INPUT VALUE
1) On-site display only
2) FieldCare only
DAMPING VALUE
MEASURED VALUE
QUICK SETUP
MEASURING MODE
GROUP SELECTION
MEASURING MODELANGUAGE
Pressure Level
OPERATING MENU
To Next Page
Loading...
