Endress+Hauser Cleanfit CPA871 - Page 36

Mounting Cleanfit CPA871
36 Endress+Hauser
Installing and removing sensors if the sensor adapter is visible (item A)
1
2
3
4
A0030156
 25 Sensor installation
1 Open-ended wrench (AF 17/19 mm)
2 Cover
3 Dummy plug
4 Sensor
Gel and KCl sensors can be installed in this version.
Install the sensor as follows:
1. Remove the cover (→  25, item 2) (only possible if the assembly is in the service
position).