Endress+Hauser CM14 - Commissioning the Device; Post-Installation Check and Power-On; Display Settings Configuration; Setup Access Protection

CM14 Commissioning
17
6 Commissioning
6.1 Installation check and switching on the device
Make sure that all post-connection checks have been carried out before you commission your
device:
•
"Installation check" checklist, (® ä 10).
•
"Post-connection check" checklist, (® ä 13).
Once the operating voltage is applied, the green LED lights up and the display indicates that the
device is operational.
When you commission the device for the first time, you program the setup in accordance with
the descriptions provided in these Operating Instructions in the following sections.
When commissioning a device already configured or preset, measuring is immediately started as
per the settings. The values of the channels currently activated appear on the display.
Remove the protective foil from the display as this restricts display legibility otherwise.
6.2 Display settings (Display menu)
Press the 'E' button during operation to call up the main menu. The Display menu appears in
the display. Pressing the 'E' key again opens the menu. Select the "x Back" option at the end of
each menu/submenu to navigate one level higher in the menu structure.
Parameter Configuration options Description
Contrast 1-7
Default: 5
Configures the display contrast.
Brightness 1-7
Default: 5
Configures the display brightness.
Display scrolling 0, 3, 5, 10 sec Switching time between the two measured
values.
0 means no switching.
6.3 Configuration of the device (Setup menu)
Press the 'E' button during operation to call up the main menu. Use the '+'- and '-' buttons to
navigate through the available menus. When the desired menu is displayed, press the 'E' key to
open the menu. Select the "x Back" option at the end of each menu/submenu to navigate one
level higher in the menu structure.
The Setup menu includes the most important settings for the function of the device.
Parameter Configuration options Description
Tag Free text
Max. 16 characters
Enter the device designation (tag).
Current range
4-20 mA
0-20 mA
Configure the measuring range for the current
output.