CM14 Safety instructions
5
►
Observe the specifications in the separate supplementary documentation that is an integral
part of these Instructions.
1.4 Designated use
The transmitter evaluates measured values of an analytical sensor and shows them on its
multicolored display. Using the unit's outputs and limit relays, processes can be monitored and
controlled. The device is equipped with a wide range of software functions for this purpose.
• The manufacturer accepts no liability for damages resulting from incorrect use or use other
than that designated. The device may not be converted or modified in any way.
• The process display unit has been designed for panel installation and may only be operated in
an installed state.
1.5 Technical improvement
The manufacturer reserves the right to adapt technical details to the most up-to-date technical
developments without prior notice. Contact your sales center for current information and updates
to these Operating Instructions.
1.6 Return
For a return, e.g. in case of repair, the device must be sent in protective packaging. The original
packaging offers the best protection. Repairs must only be carried out by your supplier's service
organization.
Enclose a note describing the fault and the application when sending the unit in for repair.
1.7 Notes on safety conventions and icons
1.7.1 Warning instructions
!
DANGER
Cause (/effects)
Where applicable, consequences of failure to comply
►
Avoidance measure
►
Indicates an imminently hazardous situation which, if not avoided, will result in death or
serious injury.
!
WARNING
Cause (/effects)
Where applicable, consequences of failure to comply
►
Avoidance measure
►
Indicates a potentially hazardous situation which, if not avoided, could result in death or
serious injury.
To Next Page
Loading...
