Endress+Hauser CM14 - Device Diagnostics (Diagnostics Menu)

Commissioning CM14
20
Parameter Configuration options Description
Set point 2 Numerical value
0.0
Only for function In band or Out band.
Hyst. Numerical value
0.0
Configures the hysteresis. Not for function
Error.
Delay time 0 to 60 s
0 s
Configure the delay until the relay switches.
Not for function Error.
Factory default Reset the device settings to the factory settings.
Please confirm no, yes Confirm reset.
6.4.1 Configuration of the relays
The device has two relays with limit values that are either switched off or can be allocated to
the input signal. The operating mode of the relays as normally open or normally closed is
determined by the wiring of the changeover contact ((® ä 35)). The limit value is entered as
a numerical value including the position of the decimal point. Limit values are always assigned
to a relay. Each relay can be assigned a channel or calculated value. In "Error" mode, the relay
acts as an alarm relay and switches for each error or alarm.
The following settings can be made for each of the two limit values: assignment, limit, hysteresis,
switching behavior, delay and fault mode.
6.5 Device diagnostics (Diagnostics menu)
Press the 'E' button during operation to call up the main menu. Use the '+'- and '-' buttons to
navigate through the available menus. When the desired menu is displayed, press the 'E' key to
open the menu. Select the "x Back" option at the end of each menu/submenu to navigate one
level higher in the menu structure.
Parameter Configuration options Description
Current diag. Read only Display the current diagnostic message
Last diag. Read only Display the last diagnostic message
Diagnost logbook Read only Display the last diagnostic messages
Device info Read only Display device information
Device tag Read only View the device designation
Device name Read only Display the device name
Serial number Read only Displays the serial number of the device
Order ident Read only Displays the order code of the device
FW revision Read only Display the firmware version
ENP version Read only Display the version of the electronic type plate
Module ID Read only Display the module ID