Cerabar S/Deltabar S/Deltapilot S FOUNDATION Fieldbus Parameter description (Local operation and FieldCare)
Endress+Hauser 191
Y-VAL.
Entry
Enter the volume, mass or %-value belonging to the X-VAL. for the linearization table.
Prerequisite:
• TABLE SELECTION = Editor table
Depending on the setting in the LINd. MEASURAND or COMB. MEASURAND
parameters, enter a volume, mass or %-value here.
→ See also this table, parameter description for LIN. EDIT MODE, LINE-NUMB, X-VAL.
("Manual" entry mode), X-VAL. ("Semiautomatic" entry mode).
EDITOR TABLE
Selection
Select the function for the editor table.
Options:
• Next point: no function
• Last input point: no function
• Accept input table: save editor table as measuring table. This overwrites the old
measuring table.
• Abort: save values entered up to this point for the editor table and display next
parameter. The editor table is not activated as a measuring table.
• Insert point: see example below.
• Delete point: the current point is deleted. See example below.
Example: Add point, in this case between the 4th and 5th point for example
– Select point 5 via the LINE NUMB parameter.
– Using the EDITOR TABLE parameter, select the "Insert point" option.
– Point 5 is displayed for the LINE NUMB parameter. Enter new values for the X-VAL
and Y-VAL parameters.
Example: Delete point, in this case the 5th point for example
– Select point 5 via the LINE NUMB parameter.
– Using the EDITOR TABLE parameter, select the "Delete point" option.
– The 5th point is deleted. All of the following points are pushed up one number i.e.
following deletion, the 6th point becomes Point 5.
Factory setting:
Next point
ACTIV LIN. TAB. X
Display
An X-value of the linearization table already saved appears on the display.
You can select a point of the linearization table via the LINE-NUMB parameter.
Prerequisite:
• TABLE SELECTION = View meas. table
!
Note!
In FieldCare, you can view the entire saved table in the "Tables" window.
ACTIV LIN. TAB. Y
Display
A Y-value of the linearization table already saved appears on the display.
You can select a point of the linearization table via the LINE-NUMB parameter.
Prerequisite:
• TABLE SELECTION = View meas. table
!
Note!
In FieldCare, you can view the entire saved table in the "Tables" window.
TANK DESCRIPTION
Entry
Enter tank description. (max. 32 alphanumeric characters)
Factory setting:
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Table 19: MANUFACTURER VIEW → OPERATING MENU → SETTINGS → LINEARIZATION – FieldCare
Parameter name Description
To Next Page
Loading...
