Commissioning Flowmeter Proline 200
36 Endress+Hauser
The desired units can be selected in the System units submenu. The wizards systematically
guide the user through all the parameters required for configuration, such as parameters for
measurement or outputs.
The wizards available in the particular device can vary on account of the device version
(e.g. sensor).
Wizard Meaning
System units Configure the units for all measured variables
Medium selection Define the medium
Pulse/frequency/switch output Configure the selected output type
Analog inputs Configure the analog inputs
Display Configure the measured value display
Low flow cut off Set the low flow cut off
Advanced setup Additional parameters for configuration:
• Medium properties
• External compensation
• Sensor adjustment
• Totalizer 1 to n
• Heartbeat
• Configuration backup display
• Administration
8.5 Defining the tag name
To enable fast identification of the measuring point within the system, you can enter a unique
designation using the Device tag parameter and thus change the factory setting.
A0029422
10 Header of the operational display with tag name
1 Tag name
Navigation
"Setup" menu → Device tag
To Next Page
Loading...
