To Next PageTo Next Page
What does SIL lock device mean on Endress+Hauser Gammapilot M FMG60 Measuring Instruments?
If the Endress+Hauser Measuring Instruments display 'SIL lock device', it means that the SIL_locking process has not been completed.
What to do if full/covered not calibrated on Endress+Hauser Measuring Instruments?
If Endress+Hauser Measuring Instruments are showing a 'full/covered not calibrated' message, perform a full/covered calibration using the calibration function group.
What to do if empty/free not calibrated on Endress+Hauser Gammapilot M FMG60 Measuring Instruments?
If Endress+Hauser Measuring Instruments are showing a 'empty/free not calibrated' message, perform an empty/free calibration using the calibration function group.
How to stop calibration integration running on Endress+Hauser Gammapilot M FMG60 Measuring Instruments?
If your Endress+Hauser Measuring Instruments are stuck on 'calibration integration running', wait until a stable pulse rate has been reached. Then, terminate the integration by pressing "E" in the "average pulse rate" function.
What to do if background not calibrated on Endress+Hauser Measuring Instruments?
If your Endress+Hauser Measuring Instruments display 'background not calibrated', perform background calibration using the calibration function group.
How to fix linearization table not plausible on Endress+Hauser Gammapilot M FMG60?
If the Endress+Hauser Measuring Instruments display 'linearization table not plausible', check the monotony of the linearization table. If necessary, adjust the table within the "linearization" function group.
What to do if Endress+Hauser Measuring Instruments show error W153?
If your Endress+Hauser Measuring Instruments display error W153, wait for completion of the initializing procedure.
What to do if Endress+Hauser Gammapilot M FMG60 show error A106?
If your Endress+Hauser Measuring Instruments display error A106, wait for completion of the download.
What to do if Endress+Hauser Gammapilot M FMG60 show error A111?
If your Endress+Hauser Measuring Instruments display error A111 due to an electronics defect, first try switching the device off and then on again. If the error persists after restarting, contact Endress+Hauser service or consider replacing the transmitter.
What happens when Endress+Hauser Measuring Instruments issues a warning error?
When a warning error occurs, the Endress+Hauser Measuring Instruments device continues measurement, and an error message is displayed, alternating with the measured value.
General| Measurement Principle | Gamma radiation absorption |
|---|---|
| Housing Material | Aluminum or stainless steel |
| Protection Class | IP66/67 |
| Radiation Source | Cesium-137 (Cs-137) or Cobalt-60 (Co-60) |
| Accuracy | ±1% of measuring range |
| Output Signal | 4 to 20 mA HART |
| Power Supply | 10.5 to 45 V DC |
| Ambient Temperature | -20 to +60 °C |
| Communication | HART |
| Certifications | ATEX, IECEx |
| Application | Density, level, or concentration measurement in liquids, solids, suspensions or slurries |
| Process Temperature | -40 to +80 °C |
