XA00303F-G Gammapilot M FMG60
18 Endress+Hauser
Position 5 (Scintillator; Measuring Range)
Selected option Description
FMG60 A-D NaJ-Crystal
G-T PVT
Optional specifications
No options specific to hazardous locations are available.
Safety instructions: General
Observe also XA00304F for the device versions marked with II 2(1) G and II 2(1) D:
Basic specification, Position 1 (Approval) = 6, 7, 8, M.
• Comply with the installation and safety instructions in the Operating Instructions.
• Staff must meet the following conditions for mounting, electrical installation, commissioning and
maintenance of the device:
– Be suitably qualified for their role and the tasks they perform
– Be trained in explosion protection
– Be familiar with national regulations
• Install the device according to the manufacturer's instructions and national regulations.
• Do not operate the device outside the specified electrical, thermal and mechanical parameters.
• Avoid electrostatic charging:
– Of plastic surfaces (e.g. housing, sensor element, special varnishing, attached additional
plates, ..)
– Of isolated capacities (e.g. isolated metallic plates)
Safety instructions:
Special conditions
In the event of additional or alternative special varnishing on the housing or other metal parts:
– Observe the danger of electrostatic charging and discharge.
– Do not rub surfaces with a dry cloth.
– Do not install in the vicinity of processes generating strong electrostatic charges.
Safety instructions:
Installation
A0031753
6
1 Pipe housing
2 Compartment housing
3 Terminal compartment A
4 Terminal compartment B
To Next Page
Loading...
