28
Endress+Hauser
HART Loop Converter HMX50
Activating Rebuild
If the connection to the field device has been lost, the localization phase can be performed
with Rebuild without switching the device off and on again.
1. Select On Rebuild with the
▴ or ▾ buttons.
2. Confirm your selection with OK.
The display On Rebuild flashes.
3. Press the OK button.
The device searches for connected field devices when booting.
4. Press the ESC button once or multiple times to switch to display mode.
3.4.7 Current Outputs
In the Output menu, you have the option of defining current outputs 1 to 3 of the device.
The menu structure is identical for the three current outputs. Current output 1 is described
as an example. For information on relay contact outputs, see chapter 3.4.8.
Output —— Iout1 —— Assignment —— disabled
▾▴ ▾ ▴ ▾▴
PV
▾▴
SV
▾▴
TV
▾▴
QV
BA00371FEN_1417.fm Page 28 Tuesday, August 15, 2017 4:08 PM
To Next Page
Loading...
