32
Endress+Hauser
HART Loop Converter HMX50
3. Select the fault current up.
The fault message is indicated by a high current value.
4. Select the fault current hold.
The last measured value before the fault occurred is stored.
5. Confirm your entry with OK.
3.4.8 Relay Contact Outputs
In the Output menu, you have the option of defining relay contact outputs 1 and 2 of the
device. The menu structure of the 2 relay contact outputs is identical. Relay contact output
1 is described as an example. Information on the current outputs see chapter 3.4.7.
Output —— Iout1
▾▴
Iout2
▾▴
Iout3
▾▴
Rel1 —— Trip value (s. page 33)
▾▴ ▾▴
Fault indication
(s. page 31)
Rel2
BA00371FEN_1417.fm Page 32 Tuesday, August 15, 2017 4:08 PM
To Next Page
Loading...
