33
Endress+Hauser
HART Loop Converter HMX50
Selecting Relay Contact Output Menus
1. Select the desired relay contact output using the
▴ or ▾ buttons.
2. Confirm your entry with OK.
The relay contact output menus trip value and fault signal are displayed. The active
menu is marked as On.
3. If you would like to activate the other menu, select this menu with
▴ or ▾.
4. Press the OK button twice.
The active menu is marked as On. The submenu is displayed.
5. If you would like to cancel activation, press the ESC button after the first OK.
Trip Value
Calling up a Trip Value
1. Select the Trip value menu with the
▴ or ▾ buttons.
2. If the trip value menu is activated, press the OK button once.
The Assignment submenu is displayed.
3. If the trip value menu is not activated, press the OK button twice.
The Assignment submenu is displayed. The trip value menu is activated and is marked
as On.
Trip value (on) —— Assignment —— disabled
▾▴ ▾▴
PV
▾▴
SV
▾▴
TV
BA00371FEN_1417.fm Page 33 Tuesday, August 15, 2017 4:08 PM
To Next Page
Loading...
