Endress+Hauser Levelflex FMP51 - Page 216

Operating menu Levelflex FMP51, FMP52, FMP54 FOUNDATION Fieldbus
216 Endress+Hauser
Factory setting Decimal
Additional information The ft-in-1/16'' option is only valid for distance units.
Decimal places menu 
Navigation  Setup → Advanced setup → Display → Dec. places menu
Description Select number of decimal places for the representation of numbers within the operating
menu.
Selection • x
• x.x
• x.xx
• x.xxx
• x.xxxx
Factory setting x.xxxx
Additional information • Is only valid for numbers in the operating menu (e.g. Empty calibration, Full
calibration), but not for the measured value display. The number of decimal places for
the measured value display is defined in the Decimal places 1 to 4 →  213
parameters.
• The setting does not affect the accuracy of the measurement or the calculations.
Backlight
Navigation  Setup → Advanced setup → Display → Backlight
Prerequisite The device has the SD03 local display (with optical keys).
Description Switch the local display backlight on and off.
Selection • Disable
• Enable
Factory setting Disable
Additional information Meaning of the options
• Disable
Switches the backlight off.
• Enable
Switches the backlight on.
Regardless of the setting in this parameter the backlight may be automatically
switched off by the device if the supply voltage is too low.