To Next PageTo Next Page
Why does the measured total level jump to lower values during filling when 'Partially filled' is selected in 'Tank level' on Endress+Hauser Measuring Instruments?
If, when 'Partially filled' is selected in 'Tank level', the measured total level jumps to lower values during filling operations, the total level may be running into the upper blocking distance. To resolve this, reduce the blocking distance.
How to fix the wrong slope of the measured interface level in Endress+Hauser Measuring Instruments?
The wrong slope of the measured interface level is caused by the wrong dielectric constant (DC value). To correct this, enter the correct dielectric constant (DC value) of the upper medium.
Why Endress+Hauser Radar device does not respond?
If your Endress+Hauser Radar device isn't responding, it could be due to a couple of reasons: * The supply voltage might not be correctly connected; ensure you connect the correct voltage. * The cables might not be making proper contact with the terminals; make sure there's good electrical contact between the cable and the terminal.
What to do if Endress+Hauser Radar device measures incorrectly?
If your Endress+Hauser Radar device is providing incorrect measurements, the cause could be a parameterization error. To solve this, check and adjust the parameterization of the device.
What to do if my Endress+Hauser Measuring Instruments device does not respond?
If your Endress+Hauser Measuring Instruments device isn't responding, there are a couple of things to check: * First, make sure the supply voltage is correctly connected. If it is not, connect the correct voltage. * Second, verify that the cables are making proper contact with the terminals. Ensure electrical contact between the cable and the terminal.
Why is the output current less than 3.6 mA on my Endress+Hauser Radar?
If the output current is less than 3.6 mA on your Endress+Hauser Radar device: * Check the signal cable connection to ensure it is correct. * Replace the electronics, as the electronics might be defective.
Why CDI communication does not work for Endress+Hauser Radar?
If CDI communication does not work with your Endress+Hauser Radar, the COM port on the computer might be set incorrectly. Check the setting of the COM port on the computer and change it if necessary.
Why CDI communication is not working on Endress+Hauser Radar?
If CDI communication does not work with your Endress+Hauser Radar, the COM port setting on your computer may be incorrect. Check the COM port setting and change it if necessary.
How to troubleshoot an Endress+Hauser Radar device that does not respond?
If the Endress+Hauser Radar device does not respond, it could be due to the following reasons: * The supply voltage is not connected. Connect the correct voltage. * The cables do not contact the terminals properly. Ensure electrical contact between the cable and the terminal.
How to fix invisible values on Endress+Hauser Radar display?
If the values on the display of your Endress+Hauser Radar are invisible, the contrast setting may be too weak or too strong. Try these steps: * Increase the contrast by pressing the designated buttons simultaneously. * Decrease the contrast by pressing the designated buttons simultaneously. Alternatively, the display cable plug might not be connected correctly, so ensure it is properly connected. If the issue persists, the display may be defective and require replacement.
General| Measuring Principle | TDR (Time Domain Reflectometry) |
|---|---|
| Measuring Range | Up to 30 m |
| Output | 4-20 mA HART, PROFIBUS PA, FOUNDATION Fieldbus |
| Power Supply | 10.5 to 36 V DC (two-wire) |
| Housing Material | Aluminum, Stainless Steel |
| Process Connection | Thread, Flange |
| Approvals | ATEX, IECEx |
| Material | PTFE |
| Protection Class | IP66/IP67 |
