Endress+Hauser Liquiphant FTL51B - Post-Installation Check; Sliding Sleeves

Liquiphant FTL51B Mounting
Endress+Hauser 15
Aligning the cable entry
1. 3.
4 0.7 Nm
2.
A0037347
 14 Housing with external locking screw
The locking screw is not tightened when the device is delivered.
1. Loosen the external locking screw (maximum 1.5 turns).
2. Turn the housing, align the cable entry.
3. Tighten the external locking screw.
4.3 Sliding sleeves
For more information, see Operating Instructions.
4.4 Post-installation check
 Is the measuring device undamaged (visual inspection)?
 Does the measuring device conform to the measuring point specifications?
For example:
• Process temperature
• Process pressure
• Ambient temperature range
• Measuring range
 Are the measuring point number and labeling correct (visual inspection)?
Is the measuring device adequately protected against precipitation and direct sunlight?
 Is the device properly secured?