Endress+Hauser Liquiphant FTL62 - Mounting the Device; Mounting Requirements and Considerations

Mounting Liquiphant FTL62
12 Endress+Hauser
5.2.2 Aligning the tuning fork using the marking
A0042207
 9 Markings to align the tuning fork
5.2.3 Installing in pipes
• Flow velocity up to 5 m/s with a viscosity of 1 mPa⋅s and density of 1 g/cm
3
(SGU).
Check for correct functioning in the event of other process medium conditions.
• The flow will not be significantly impeded if the tuning fork is correctly aligned and the
marking is pointing in the direction of flow.
• The marking is visible when installed.
A0042208
 10 Installation in pipes (take fork position and marking into consideration)