Micropilot FMR53, FMR54
88 Endress+Hauser
Feature 100 in the product structure Process connection
AFJ NPS 2" Cl.150 RF, 316/316L
AFK NPS 2" Cl.150, PTFE >316/316L
AGJ NPS 3" Cl.150 RF, 316/316L
AGK NPS 3" Cl.150, PTFE >316/316L
AHJ NPS 4" Cl.150 RF, 316/316L
AHK NPS 4" Cl.150, PTFE >316/316L
AJJ NPS 6" Cl.150 RF, 316/316L
AJK NPS 6" Cl.150, PTFE >316/316L
AKJ NPS 8" Cl.150 RF, 316/316L
ALJ NPS 10" Cl.150 RF, 316/316L
AMJ NPS 12" Cl.150 RF, 316/316L
ASJ NPS 3" Cl.300 RF, 316/316L
ATJ NPS 4" Cl.300 RF, 316/316L
AUJ NPS 6" Cl.300 RF, 316/316L
AUK NPS 6" Cl.300, PTFE>316/316L
AVJ NPS 8" Cl.300 RF, 316/316L
RGF Thread ANSI MNPT1-1/2, PVDF
RGJ Thread ANSI MNPT1-1/2, 316L
RVF Thread EN10226 R1-1/2, PVDF
RVJ Thread EN10226 R1-1/2, 316L
• Process connections that do not have CRN approval are not listed in this table.
• Please refer to the product structure to discover which process connections are available for a
specific device type.
• A CRN approval is available on request for some process connections not listed in the product
structure.
• CRN-approved devices are labeled with registration number OF15872.5C on the nameplate.
An additional pressure restriction applies for the device versions listed in the table below if they
are CRN-approved. The pressure range indicated in the "Process" section continues to apply for
device versions not listed in the table below.
Product Antenna
1)
Process connection
2)
Seal
3)
Max. pressure
FMR54 D1: graphite (XT) 100 bar (1 450 psi)
D2: graphite (HT) 100 bar (1 450 psi)
1) Feature 070 in the product structure
2) Feature 100 in the product structure
3) Feature 090 in the product structure
To Next Page
Loading...
