Basic safety instructions Nivector FTI26
6 Endress+Hauser
1.9 Registered trademarks
is a registered trademark of the IO-Link company group.
2 Basic safety instructions
2.1 Requirements for the personnel
The personnel must fulfill the following requirements for its tasks:
‣
Trained, qualified specialists must have a relevant qualification for this specific function
and task.
‣
Are authorized by the plant owner/operator.
‣
Are familiar with federal/national regulations.
‣
Before starting work, read and understand the instructions in the manual and
supplementary documentation as well as the certificates (depending on the application).
‣
Follow instructions and comply with basic conditions.
2.2 Designated use
The measuring device described in these instructions may be used only as a point level switch
for powdery and fine-grained bulk solids. Incorrect use may pose a hazard. To ensure that the
measuring device remains in perfect condition during the operating time:
• Measuring devices must be used only for media to which the process-wetted materials have
an adequate level of resistance.
• The relevant limit values must not be violated, see TI01384F/00/EN.
2.2.1 Incorrect use
The manufacturer is not liable for damage caused by improper or non-designated use.
Residual risks
Due to heat transfer from the process, the temperature of the electronics housing and the
assemblies contained therein may rise to 80 °C (176 °F) during operation.
L
CAUTION
Hot surfaces
Danger of burns from contact with surfaces!
‣
In the event of elevated fluid temperatures, ensure protection against contact to prevent
burns.
2.3 Workplace safety
For work on and with the device:
‣
Wear the required personal protective equipment according to federal/national
regulations.
To Next Page
Loading...
Need help?
General
