Nivector FTI26 Product description
Endress+Hauser 7
2.4 Operational safety
L
CAUTION
Risk of injury!
‣
The operator is responsible for the trouble-free operation of the device.
‣
Operate the device only if it is in proper technical condition, free from errors and faults.
‣
The device must be operated with a 500 mA fine-wire fuse (slow-blow) which is suitable
for DC current in accordance with IEC 60127-2.
2.5 Product safety
This measuring device is designed in accordance with good engineering practice to meet state-
of-the-art safety requirements, has been tested, and left the factory in a condition in which it
is safe to operate.
It meets general safety standards and legal requirements. It also complies with the EC
directives listed in the device-specific EC Declaration of Conformity. Endress+Hauser confirms
this by affixing the CE mark to the device.
2.6 IT security
Our warranty is valid only if the device is installed and used as described in the Operating
Instructions. The device is equipped with security mechanisms to protect it against any
inadvertent changes to the settings.
IT security measures, which provide additional protection for the device and associated data
transfer, must be implemented by the operators themselves in line with their security
standards.
3 Product description
Capacitance point level switch for powdery and fine-grained bulk solids; use preferably in bulk
solids vessels, e.g. silos
To Next Page
Loading...
Need help?
General
