Basic safety instructions Nivector FTI26
6 Endress+Hauser
2 Basic safety instructions
2.1 Requirements for the personnel
The personnel for installation, commissioning, diagnostics and maintenance must fulfill
the following requirements:
‣
Trained, qualified specialists must have a relevant qualification for this specific function
and task.
‣
Are authorized by the plant owner/operator.
‣
Are familiar with federal/national regulations.
‣
Before starting work, read and understand the instructions in the manual and
supplementary documentation as well as the certificates (depending on the
application).
‣
Follow instructions and comply with basic conditions.
The operating personnel must fulfill the following requirements:
‣
Are instructed and authorized according to the requirements of the task by the facility's
owner-operator.
‣
Follow the instructions in this manual.
2.2 Designated use
The measuring device described in these instructions may be used only as a point level
switch for powdery and fine-grained bulk solids. Incorrect use may pose a hazard. To
ensure that the measuring device remains in perfect condition during the operating time:
• Measuring devices must be used only for media to which the process-wetted materials
have an adequate level of resistance.
• The relevant limit values must not be violated, see TI01384F/00/EN.
2.2.1 Incorrect use
The manufacturer is not liable for damage caused by improper or non-designated use.
Residual risks
Due to heat transfer from the process, the temperature of the electronics housing and the
assemblies contained therein may rise to 80 °C (176 °F) during operation.
L
CAUTION
Hot surfaces
Danger of burns from contact with surfaces!
‣
In the event of elevated fluid temperatures, ensure protection against contact to
prevent burns.
2.3 Workplace safety
For work on and with the device:
‣
Wear the required personal protective equipment according to federal/national
regulations.
To Next Page
Loading...
Need help?
General
