Endress+Hauser NRF81 - Page 154

Operating menu Tankside Monitor NRF81
154 Endress+Hauser
"Configuration" submenu
This submenu is only present for devices with a MODBUS communication interface.
Navigation  Setup → Advanced setup → Communication → Modbus X1-4
→ Configuration
Baudrate 
Navigation  Setup → Advanced setup → Communication → Modbus X1-4 → Configuration
→ Baudrate
Prerequisite Communication interface protocol (→  153) = MODBUS
Description Defines the baud rate of the Modbus communication.
Selection • 300 BAUD
• 1200 BAUD
• 2400 BAUD
• 4800 BAUD
• 9600 BAUD
• 19200 BAUD
Factory setting 9600 BAUD
Additional information
Read access Operator
Write access Maintenance
Parity 
Navigation  Setup → Advanced setup → Communication → Modbus X1-4 → Configuration
→ Parity
Prerequisite Communication interface protocol (→  153) = MODBUS
Description Defines the parity of the Modbus communication.
Selection • Odd
• Even
• None / 1 stop bit
• None / 2 stop bits
Factory setting None / 1 stop bit
Additional information
Read access Operator
Write access Maintenance