Endress+Hauser NRF81 - Page 165

Tankside Monitor NRF81 Operating menu
Endress+Hauser 165
Description Assigns a current to the primary HART variable (PV).
Selection • None
• AIO B1-3 value mA
• AIO C1-3 value mA
Factory setting None
Additional information
Read access Operator
Write access Maintenance
Primary variable (PV)
Navigation  Setup → Advanced setup → Communication → HART output → Configuration
→ Primary variable (PV)
Description Shows the value of the primary HART variable (PV).
Additional information
Read access Operator
Write access -
Percent of range
Navigation  Setup → Advanced setup → Communication → HART output → Configuration
→ Percent of range
Description Shows the value of the primary variable (PV) as a percentage of the defined 0% to 100%
range.
Additional information
Read access Operator
Write access -
Assign SV 
Navigation  Setup → Advanced setup → Communication → HART output → Configuration
→ Assign SV
Description Assigns a tank variable to the secondary HART variable (SV).
Selection • None
• Tank level
• Tank ullage
• Measured level
• Distance
• Displacer position