Endress+Hauser NRF81 - Page 179

Tankside Monitor NRF81 Operating menu
Endress+Hauser 179
"Density" submenu
Navigation  Setup → Advanced setup → Application → Tank configuration
→ Density
Observed density source 
Navigation  Setup → Advanced setup → Application → Tank configuration → Density → Observed
density source
Description Determines how the density is obtained.
Selection • HTG
• HTMS
• Average profile density
*
• Upper density
• Middle density
• Lower density
Factory setting Dependent on the device version
Additional information
Read access Operator
Write access Maintenance
Observed density
Navigation  Setup → Advanced setup → Application → Tank configuration → Density → Observed
density
Description Shows the measured or calculated density.
Additional information
Read access Operator
Write access -
Air density 
Navigation  Setup → Advanced setup → Application → Tank configuration → Density → Air
density
Description Defines the density of the air surrounding the tank.
User entry 0.0 to 500.0 kg/m³
* Visibility depends on order options or device settings