Endress+Hauser NRF81 - Page 206

Operating menu Tankside Monitor NRF81
206 Endress+Hauser
Description of parameters
Navigation  Setup → Advanced setup → Application → Tank calculation
→ HTG
Density value
Navigation  Setup → Advanced setup → Application → Tank calculation → HTG → Density value
Description Shows the density calculated by HTG.
Additional information
Read access Operator
Write access -
Tank level
Navigation  Setup → Advanced setup → Application → Tank calculation → HTG → Tank level
Description Shows the level calculated by HTG.
User interface Signed floating-point number
Factory setting 0 mm
Additional information
Read access Operator
Write access -
HTG mode 
Navigation  Setup → Advanced setup → Application → Tank calculation → HTG → HTG mode
Description Defines the HTG mode.
Selection • P1 only
• P1 + P3
• P1 + P2
• P1 + P2 + P3
Factory setting P1 only
Additional information
Read access Operator
Write access Maintenance