Endress+Hauser NRF81 - Page 224

Operating menu Tankside Monitor NRF81
224 Endress+Hauser
Selection • 1 value, max. size
• 1 bargraph + 1 value
• 2 values
• 1 value large + 2 values
• 4 values
Factory setting 1 value, max. size
Additional information
Read access Operator
Write access Operator
• The Value 1 to 4 display (→  224) parameters specify which measured values are
shown on the display and in which order.
• If more measured values are specified than the current display mode permits, the values
alternate on the device display. The display time until the next change is configured in
the Display interval parameter (→  227).
Value 1 to 4 display 
Navigation  Setup → Advanced setup → Display → Value 1 display
Prerequisite The device has a local display.
Description Select the measured value that is shown on the local display.
Selection • None
7)
• Tank level
• Measured level
• Tank level %
• Water level
7)
• Liquid temperature
7)
• Vapor temperature
7)
• Air temperature
7)
• Tank ullage
• Tank ullage %
• Observed density value
7)
• P1 (bottom)
7)
• P2 (middle)
7)
• P3 (top)
7)
• GP 1 value
7)
• GP 2 value
7)
• GP 3 value
7)
• GP 4 value
7)
• Gauge command
7)
• Gauge status
7)
• AIO B1-3 value
7)
• AIO B1-3 value mA
7)
• AIO B1-3 value %
7)
• AIO C1-3 value
7)
• AIO C1-3 value mA
7)
• AIO C1-3 value %
7)
7) not available for the Value 1 display parameter