Endress+Hauser NRF81 - Page 63

Tankside Monitor NRF81 Commissioning
Endress+Hauser 63
8.
2
1
3
A0029269
1 Datum plate
2 RTD
3 Probe position (→  136)
Go to the Probe position parameter and enter the mounting position of the RTD
(measured from the datum plate).
 This parameter, in conjunction with the measured level, determines whether the
measured temperature refers to the product or to the gas phase.
Offset for resistance and/or temperature
An offset for the resistance or the temperature can be defined in the following
submenu: Expert → Input/output → Analog IP X4-8.
• Ohms offset is added to the measured resistance before the calculation of the
temperature.
• Temperature offset after conversion is added to the measured temperature.
R[ ]Ω
R[ ]Ω
T T
1
2
A0029265
1 Ohms offset
2 Temperature offset after conversion