To Next PageTo Next PageWhat to do if Endress+Hauser Measuring Instruments show error A111?
If your Endress+Hauser Measuring Instruments display error A111 due to an electronics defect, first try switching the device off and then on again. If the error persists after restarting, contact Endress+Hauser service or consider replacing the transmitter.
What does SIL lock device mean on Endress+Hauser PROFIBUS PA Measuring Instruments?
If the Endress+Hauser Measuring Instruments display 'SIL lock device', it means that the SIL_locking process has not been completed.
What happens when Endress+Hauser Measuring Instruments issues a warning error?
When a warning error occurs, the Endress+Hauser Measuring Instruments device continues measurement, and an error message is displayed, alternating with the measured value.
What happens when Endress+Hauser PROFIBUS PA display an alarm error?
When an alarm occurs on your Endress+Hauser Measuring Instruments, the output signal will assume a value set using the "output on alarm" function. This value can be MAX (+99999), MIN (-99999), or HOLD (last value is on hold). Also, an error message is displayed.
What to do if sensor electronics defect on Endress+Hauser PROFIBUS PA?
If you are facing an 'sensor electronics defect' error with your Endress+Hauser Measuring Instruments, try switching the instrument off and on.
How to fix 'Linearization table not defined' on Endress+Hauser PROFIBUS PA Measuring Instruments?
To resolve the 'Linearization table not defined' error on your Endress+Hauser Measuring Instruments, enter or complete the linearization table in the "linearization" (*4) function group. Ensure the table contains the endpoints 0% = 1000 cps (standardized) and 100% = 0 cps (standardized). When entering via FieldCare, select the correct table type (lin. tab. "level" or "concentration").
What to do if Endress+Hauser Measuring Instruments have download error?
To resolve a 'Download error' on your Endress+Hauser Measuring Instruments, repeat the download process.
What to do if background not calibrated on Endress+Hauser PROFIBUS PA Measuring Instruments?
If your Endress+Hauser Measuring Instruments display 'background not calibrated', perform background calibration using the calibration function group.
How to stop calibration integration running on Endress+Hauser Measuring Instruments?
If your Endress+Hauser Measuring Instruments are stuck on 'calibration integration running', wait until a stable pulse rate has been reached. Then, terminate the integration by pressing "E" in the "average pulse rate" function.
What to do if empty/free not calibrated on Endress+Hauser Measuring Instruments?
If Endress+Hauser Measuring Instruments are showing a 'empty/free not calibrated' message, perform an empty/free calibration using the calibration function group.
General| Communication Protocol | PROFIBUS PA |
|---|---|
| Manufacturer | Endress+Hauser |
| Power supply | 9-32 V DC (via PROFIBUS PA) |
| Protection class | IP67 |
| Housing material | Stainless steel or plastic |
