Endress+Hauser Prosonic M FMU41 - Operation using the on-site display VU331

Prosonic M - FOUNDATION Fieldbus Operation
Endress+Hauser 35
L00-FMU4XXXX-02-00-00-YY-005
The highlighted parameters can be edited by on-site operation.
5.5 Operation using the on-site display VU331
L00-FMU4xxxx-19-00-00-en-018
1. Change from Measured Value Display to Group Selection by pressing F.
2. Press S or O to select the required Function Group and confirm by pressing F.
The active selection is marked by a ¸ in front of the menu text.
3. Activate Edit mode with O or S .
Selection menus
a. Select the required Parameter in selected function with S oder O .
b. F confirms selection; ¸ appears in front of the selected parameter.
c. F confirms the edited value; system quits edit mode.
d. O and S (= Q) interrupts selection; system quits edit mode.
Typing in numerals and text
a. Press O or S to edit the first character of the numeral / text.
b. F positions the cursor at the next character; continue with a. until you have completed
your input.
Endress+Hauser
Service-Parameter
Sensorblock
Diagnoseblock
Display-Block
Resource Block
AI-Block 1
AI-Block 2
PID Block
Arithmetik-Block
Input-Selector-Block
Signal-Charact.-Block
Integrator-Block
X
X
X
X
S
SS
O
OO
FF
>3 s
F
ENDRESS + HAUSER
E
+–
...
2x
...
...
unknown
liquid
solid<4mm
solid>4mm
Return to
Group Selection
basic setup
safety settings
temperature
linearisation
tank shape
dome ceiling
horizontal cyl
bypass
stilling well
flat ceiling
sphere
no ceiling
medium property