5 Electrical connection Digital field display
36
The electronic component can be hinged forwards for simple
installation and easy cable laying.
ƒig. 4: Electrical connection
In order to do this follow these instructions:
• Loosen and remove the unit lid.
• Hold the top of the electronics and pull forwards and down,
(see sketch).
5.1.3 Connecting active current source
E.g. a sensor with its own power supply and active current
output:
#
Note: If a respective barrier is used the unit can be installed
directly in the hazardous area.
ƒig. 5: Connecting active current source
G_09_RIA261_Z_Z_11_00_01_xx_001.eps
G-09-RIA261ZZ-04-00-00-en-002.eps
To Next Page
Loading...
