6 Operation Digital field display
38
6.2 Display and operating elements
ƒig. 7: Display and operating elements
Measured value:
5 digit, LC display, indicated are:
• Instantaneous numeric measured value (in operation).
• Dialogue setting up text.
Bargraph:
The bargraph displays the scaled measuring range. It
indicates the instantaneous percentage measured value.
Enter push button (E):
Entry into set-up menu.
• Selection of operating function in a function group.
• Saving set-up data.
Selection push buttons (+, -):
• Selection of a function group within the menu.
• Setting up parameters and numbers. (If the push button is
continuously held down then the number change on the
display increases).
• The actual loop circuit current is displayed if the +/- push
buttons are held down in operation mode.
Identification fields:
Additional information can be written into the identification
fields.
In order to do so, follow these instructions:
• Degrease and clean the fields.
• Write onto the fields using a light and water resistant
transparency pen.
G-09-RIA261ZZ-19-00-00-xx-001.eps
To Next Page
Loading...
