Endress+Hauser silometer FMC 671 Z - 3 Operating Elements; Commutec Operating Matrix

3 Operating elements
This Chapter describes how the Silometer FMC 671 Z/676 Z transmitters are operated.
It is divided into the following sections:
• Commutec operating matrix
• Operating and display elements: Silometer FMC 671 Z
• Operating and display elements: Silometer FMC 676 Z
3.1 Commutec operating matrix
All functions, including the analogue outputs and relay switch points are configured via
the operating matrix, see Figs 3.1 and 3.2:
• Each field in the matrix is accessed by a vertical (V) and horizontal (H)
position which can be entered at the front panel of the FMC 671 Z, by the
Commulog VU 260 Z and via a ZA 67… computer gateway.
• For information on ZA 67… operation see the operating manual BA 054F/00/en
and Technical Information sheet »Commutec Operating Program« TI 113F.
Operating matrix see page 62, 63.
Current matrix position
Silometer FMC 671 display
Parameter at
current matrix position
Pressed together V, H:
move to V0H0
Move H0
…
H9, H0
Move V0
…
V9, V0
BA063E25
Fig. 3.1:
Silometer FMC 671 Z
Parameter matrix operation with
function of V and H keys.
The complete matrix has 10 x 10
fields, although not all are used
Diagnostics key -
press when icon blinks
Escape key -
move to field 00
Entry key -
call or quit parameter
Matrix selection keys -
press to move about matrix
BA063E26
Commulog display
Parameter
Bar chart of
analogue signal
Fig. 3.2:
Commulog display and key
functions for the Silometer
FMC 671 Z/676 Z
The Tag No. and measurement
units are entered in the VA level
which can be accessed by the
Commulog or ZA 67
…
interface
only
Silometer FMC 671 Z/676 Z Chapter 3: Operating elements
19