EasyManuals Logo

EnerSys PowerSafe User Manual

EnerSys PowerSafe
46 pages
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #46 background imageLoading...
Page #46 background image
PRECAUTIONS*
1.
Do Not bring any heat or flame source near battery.
2.
Do Not lift any cells by the terminal posts.
3.
Do Not remove coating from post or connectors and expose any bare copper.
4.
Do Not clean cell with anything other than water/bicarbonate of soda.
5.
Do Not over torque connections.
6.
Do Not exceed EnerSys recommended storage intervals without refreshing charge.
* These are only a few of the precautions. Please read this manual thoroughly for
complete details.
USE EDGE OF MODULE
WHEN POSITIONING BATTERY
DO NOT PUSH ON CENTER
TO POSITION BATTERY
WARNING
Do Not use any lubricant other than EnerSys
®
Pro-Slide or Dow
Corning Silicon Compound #111 to lubricate rails to facilitate
sliding of batteries.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the EnerSys PowerSafe and is the answer not in the manual?

EnerSys PowerSafe Specifications

General IconGeneral
BrandEnerSys
ModelPowerSafe
CategoryCamera Accessories
LanguageEnglish

Related product manuals