ENFORCER Voice Dialer
SECO-LARM U.S.A., Inc. 11
2. To disarm the system, enter the PIN number and press the [ARM/DISARM] button.
The dialer will sound a long “beep” and the word “ARM” will disappear from the LCD screen.
Panic Button Use
1. When the [PANIC] button is pressed, the siren will sound immediately and auto dialing will
commence without delay. If the siren has been programmed to “SOUND OFF” the siren will not
sound, but silent dialing will commence.
2. To cancel the alarm and stop auto dialin
, enter the PIN number and press the [ARM/DISARM]
button. The dialer is now disarmed.
Note: When the siren has been programmed to “SOUND OFF,” the siren will not sound and
the dialing will commence silently after the delay time has passed. When the call is answered,
the receiver will hear the user-recorded 20-second emergency message.
Note: If the voice dialer is not connected to a working telephone line, the dialer will “beep” 4
times and the siren will begin to sound without attempting to continue dialing out (this
overrides the “SOUND OFF” setting).
Remote Control by Telephone
The system can be remotely controlled and monitored through any Touch-Tone phone, including
mobile phones. The user may either arm or disarm the system, listen in on any activity in the room,
or broadcast a message to those in the room.
1. REMOTE CONTROL WHEN ALARM IS ACTIVATED
When an alarm has been activated and the voice dialer dials the pre-programmed emergency
numbers, the person who answers the call will hear the pre-recorded message and may press
one of the following function codes at any time to control the system remotely:
Function Press key code
Listen in 1 #
Broadcast 2 #
End call 3 #
Disarm system 6 #
The user should hear a “beep” in response. If not, enter the function code again.
2. REMOTE CONTROL BY USER CALL-IN (CALL BACK)
A. Using a mobile phone or any Touch-Tone phone, dial the phone number that the voice
dialer is connected to. The voice dialer will answer and “beep” once after the number of
rings in the pre-programmed call-in ringer detect cycle (3, 5, 7, or 10 rings, see pg. 8).
B. Enter the PIN Number on the phone’s keypad. The dialer will “beep” twice if the correct
code has been entered. If a wrong code is entered, the dialer will disconnect automatically
and the user must dial in again.
Operating the Voice Dialer, continued:
To Next Page
Loading...
Need help?
General
